State of the Art: Mechanical Properties of Ultra-High Performance Concrete
Abstract
During the past decades, there has been an extensive attention in using Ultra-High Performance Concrete (UHPC) in the buildings and infrastructures construction. Due to that, defining comprehensive mechanical properties of UHPC required to design structural members is worthwhile. The main difference of UHPC with the conventional concrete is the very high strength of UHPC, resulting designing elements with less weight and smaller sizes. However, there have been no globally accepted UHPC properties to be implemented in the designing process. Therefore, in the current study, the UHPC mechanical properties such as compressive and tensile strength, modulus of elasticity and development length for designing purposes are provided based on the reviewed literature. According to that, the best-recommended properties of UHPC that can be used in designing of UHPC members are summarized. Finally, different topics for future works and researches on UHPC’s mechanical properties are suggested.
Keywords
References
Fesharaki, M. and A. Hamedi, EFFECTS OF HIGH-SPEED RAIL SUBSTRUCTURE ON GROUND-BORNE VIBRATIONS. 2016. Florida Civil Engineering Journal, 2016. 2: p. 38–47.
Fesharaki, M. and T.-L. Wang, The Effect of Rail Defects on Track Impact Factors. Civil Engineering Journal, 2016. 2(9): p. 458-473.
Hamedi, A., Ketabdar, M., Fesharaki, M., & Mansoori, A., Nappe Flow Regime Energy Loss in Stepped Chutes Equipped with Reverse Inclined Steps: Experimental Development. Florida Civil Engineering Journal, 2016. 2: p. 28-37.
Ali, H. and Mohammadafzali, M. , Asphalt Surface Treatment Practice in Southeastern United States, Louisiana Transportation Research Center. 2014.
Ali, H. Massahi, Aidin, Hesham Ali, Farshad Koohifar, and Mojtaba Mohammadafzali. Analysis of pavement raveling using smartphone. In Transportation Research Board 95th Annual Meeting, no. 16-6155. 2016.
Russell, H.G. and B.A. Graybeal, Ultra-high performance concrete: A state-of-the-art report for the bridge community. 2013.
Azizhemmatlou, Y., Hamedi, A., Farbehi, H., Iranyar, D. The Optimum water to cement ratio for designing impermeable water storage tanks. in 1st International Conference on Non Osmosis Concrete(1st ICNOC)-Water Storage Tanks. Guilan, Iran. 2011.
Ghasemi, S., et al., Novel UHPC-CFRP Waffle Deck Panel System for Accelerated Bridge Construction. Journal of Composites for Construction, 2015. 20(1): p. 04015042.
Ghasemi, S., et al., A super lightweight UHPC–HSS deck panel for movable bridges. Engineering Structures, 2016. 113: p. 186-193.
Amir-sayyafi, E., A.G. Chowdhury, and A. Mirmiran. A supper Lightweight Hurrican-Resistant Thin-Walled Box-cell Roofing System. in International Symposium on Structural Engineering, 2016, in press.
Baqersad, M., Haghighat, A. E., Rowshanzamir, M., & Bak, H. M., Comparison of Coupled and Uncoupled Consolidation Equations Using Finite Element Method in Plane-Strain Condition. Civil Engineering Journal, 2016. 2(8): p. 375-388.
Habel, K., et al., Ultra-high performance fibre reinforced concrete mix design in central Canada. Canadian Journal of Civil Engineering, 2008. 35(2): p. 217-224.
Holschemacher, K. and D. Weiße, Economic Mix Design Ultra High-Strength Concrete. Seventh International Symposium on the Utilization of High-Strength/High-Performance Concrete, 2005. Vol. II: p. 133–1,144.
Graybeal, B.A., Characterization of the behavior of ultra-high performance concrete. 2005.
Tran, N.T., et al., Fracture energy of ultra-high-performance fiber-reinforced concrete at high strain rates. Cement and Concrete Research, 2016. 79: p. 169-184.
King, K.W., J.H. Wawclawczyk, and C. Ozbey, Retrofit strategies to protect structures from blast loading This article is one of a selection of papers published in the Special Issue on Blast Engineering. Canadian Journal of Civil Engineering, 2009. 36(8): p. 1345-1355.
Aboutaha, R.S. and R. Machado, Seismic resistance of steel confined reinforced concrete (SCRC) columns. The Structural Design of Tall Buildings, 1998. 7(3): p. 251-260.
ALlexander, S. and S.H. Simmonds, Punching shear tests of concrete slab-column joints containing fiber reinforcement. Structural Journal, 1992. 89(4): p. 425-432.
Kim, J.J., et al., High-rate tensile behavior of steel fiber-reinforced concrete for nuclear power plants. Nuclear Engineering and Design, 2014. 266: p. 43-54.
Abbas, S., M. Nehdi, and M. Saleem, Ultra-High Performance Concrete: Mechanical Performance, Durability, Sustainability and Implementation Challenges. International Journal of Concrete Structures and Materials, 2016. 10(3): p. 271-295.
Aaleti, S., B. Petersen, and S. Sritharan, Design Guide for Precast UHPC Waffle Deck Panel System, Including Connections. 2013.
Saleem, M.A., et al., Ultra-high-performance concrete bridge deck reinforced with high-strength steel. ACI Structural Journal, 2011. 108(5): p. 601.
Ahmad, I., Suksawang, N., Sobhan, K., Corven, J., Sayyafi, E. A., Pant, S., & Martinez, F., Develop Epoxy Grout Pourback Guidance and Test Methods to Eliminate Thermal/Shrinkage Cracking at Post-Tensioning Anchorages: Phase II. 2015.
Richard, P. and M. Cheyrezy, Composition of reactive powder concretes. Cement and concrete research, 1995. 25(7): p. 1501-1511.
Ma, J., et al. Comparative investigations on ultra-high performance concrete with and without coarse aggregates. in Proceedings of international symposium on ultra high performance concrete, Germany. 2004.
Scheydt, J.C. and H. Müller. Microstructure of ultra high performance concrete (UHPC) and its impact on durability. in The 3rd International Symposium on UHPC and Nanotechnology for High Performance Construction Materials, Kassel, Germany. 2012.
Yuan, J. and B.A. Graybeal, Bond behavior of reinforcing steel in ultra-high performance concrete. 2014.
Barnett, S.J., et al., Assessment of fibre orientation in ultra high performance fibre reinforced concrete and its effect on flexural strength. Materials and Structures, 2010. 43(7): p. 1009-1023.
Perry, V. and D. Zakariasen. Overview of UHPC technology, materials, properties, markets and manufacturing. in Proceedings of the 2003 Concrete Bridge Conference. 2003.
Harris, D.K. and C.L. Roberts-Wollmann, Characterization of the punching shear capacity of thin ultra-high performance concrete slabs. 2005.
Reda, M., N. Shrive, and J. Gillott, Microstructural investigation of innovative UHPC. Cement and Concrete Research, 1999. 29(3): p. 323-329.
AFGC-SETRA, U.H.P.F., Reinforced Concretes. Interim Recommendations, AFGC Publication, France, 2002.
Graybeal, B.A. and F. Baby, Development of Direct Tension Test Method for Ultra-High-Performance Fiber-Reinforced Concrete. ACI Materials Journal, 2013. 110(2).
Graybeal, B.A., Splice length of prestressing strands in field-cast UHPC connections. Materials and Structures, 2015. 48(6): p. 1831-1839.
Graybeal, B., Design and construction of field-cast UHPC Connections. 2014.
BFUP, A., Ultra-High Performance Fibre-Reinforced Concretes. Interim Recommendations, AFGC publication, France, 2002.
Gowripalan, N. and R. Gilbert, Design Guidelines for Ductal Prestressed Concrete Beams. Reference Artical, The University of NSW, 2000.
Rokugo, K., Recommendations for design and construction of High Performance Fiber Reinforced Cement Composites with multiple fine cracks (HPFRCC). 2008: Japan Society of Civil Engineers, Concrete Committee.
Graybeal, B.A., Material property characterization of ultra-high performance concrete. 2006.
Standard Test Method for Static Modulus of Elasticity and Poisson’s Ratio of Concrete in Compression. 2014, ASTM International.
Graybeal, B.A., Flexural behavior of an ultrahigh-performance concrete I-girder. Journal of Bridge Engineering, 2008. 13(6): p. 602-610.
Hassan, A. and S. Jones, Non-destructive testing of ultra high performance fibre reinforced concrete (UHPFRC): A feasibility study for using ultrasonic and resonant frequency testing techniques. Construction and Building Materials, 2012. 35: p. 361-367.
Cheyrezy, M. and M. Behloul, Creep and shrinkage of ultra-high performance concrete. Creep, Shrinkage and Durability Mechanics of concrete and other Quasi-Brittle Materials”, édité par F.-J. Ulm, ZP Ba. ant and FH Witmann, Elsevier, Cambridge, 2001: p. 527-538.
Saleem, M.A., et al., Development length of high-strength steel rebar in ultrahigh performance concrete. Journal of Materials in Civil Engineering, 2012. 25(8): p. 991-998.
Ronanki, V.S., D.B. Valentim, and S. Aaleti, Development length of reinforcing bars in UHPC: An experimental and analytical investigation.
Vic Perry, F., et al., Innovative Field Cast UHPC Joints for Precast Bridge Systems–3-span Live Load Continuous. 2010.
Hassan, A., S. Jones, and G. Mahmud, Experimental test methods to determine the uniaxial tensile and compressive behaviour of ultra high performance fibre reinforced concrete (UHPFRC). Construction and building materials, 2012. 37: p. 874-882.
Ronanki, V.S., D.B. Valentim, and S. Aaleti, Development length of reinforcing bars in UHPC: An experimental and analytical investigation. 2016.
John, E., et al., Transfer and development lengths and prestress losses in ultra-high-performance concrete beams. Transportation Research Record: Journal of the Transportation Research Board, 2011(2251): p. 76-81.
Prem, P., B. Bharathkumar, and R.I. Nagesh, Mechanical properties of ultra high performance concrete. World academy of Science, Engineering and Technology, 2012(68): p. 1969-1978.
Ghasemi, S., Innovative Modular High Performance Lightweight Decks for Accelerated Bridge Construction. 2015.
DOI: 10.28991/cej-2017-00000085
Refbacks
- There are currently no refbacks.
Copyright (c) 2017 Mohamadtaqi Baqersad, Ehsan Amir Sayyafi, Hamid Mortazavi Bak
This work is licensed under a Creative Commons Attribution 4.0 International License.