Effect of Compaction Energy on Engineering Properties of Expansive Soil

Sadam Hussain

Abstract


Swelling of expansive clays is one of the great hazards, a foundation engineer encounters. Each year expansive soils cause severe damage to residences, buildings, highways, pipelines, and other civil engineering structures. Strength and deformation parameters of soils are normally related to soil type and moisture. However, surprisingly limited focus has been directed to the compaction energy applied to the soil. Study presented herein is proposed to examine the effect of varying compaction energy of the engineering properties i.e. compaction characteristics, unconfined compressive strength, California bearing ratio and swell percentage of soil. When compaction energy increased from 237 KJ/m3 to 1197 KJ/m3, MDD increased from 1.61 g/cm3 to 1.75 g/cm3, OMC reduced from 31.55 percent to 21.63 percent, UCS increased from 110.8 to 230.6 KPa, and CBR increased from mere 1 percent to 10.2 percent. Results indicate substantial improvement in these properties. So, compacting soil at higher compaction energy levels can provide an effective approach for stabilization of expansive soils up to a particular limit. But if the soil is compacted more than this limit, an increase in swell potential of soil is noticed due to the reduction in permeability of soil.


Keywords


Expansive Soils; Compaction Energy; Compaction Characteristics; Unconfined Compressive Strength; Swell Potential; Soaked California Bearing Ratio.

References


Seed, H. Bolton, Richard J. Woodward, and Raymond Lundgren. "Prediction of swelling potential for compacted clays." Transactions of the American Society of Civil Engineers 128.1 (1962): 1443-1477.

Attom, M. F. The effect of compactive energy level on some soil properties. Applied Clay Science, 1997, 12(1-2), 61-72.

Sridharan, A., and Y. Gurtug. "Swelling behaviour of compacted fine-grained soils." Engineering Geology 72.1 (2004): 9-18.

Drew, I., & White, D. J. Influence of Compaction Energy on Soil Engineering Properties. In The 2005 Mid-Continent Transportation Research Symposium, 2005.

Nwaiwu, C., Mshelia, S., & Durkwa, J. Compactive effort influence on properties of quarry dust-black cotton soil mixtures. International Journal of Geotechnical Engineering, 2012, 6(1), 91-101.

Amarnath, M. S. Strength and performance characteristics of soil compacted at different energy levels. International Journal of Earth Sciences and Engineering, 2012, 5(2), 347-351.

S.R. Jolly, and P.Vinod, “Effect of compactive energy on compaction characteristics of soil, Proceedings of Indian Geotechnical Conference, pp.143-146, 2012.

Vinod, P. P., Sridharan, A., & Soumya, R. J. Effect of compaction energy on CBR and compaction behavior. Proceedings of the Institution of Civil Engineers-Ground Improvement, 2015, 168(2), 116-121.

Sabat, A. K., & Moharana, R. K (2015). Effect of Compaction Energy on Engineering Properties of Fly Ash–Granite Dust Stabilized Expansive Soil.

ASTM D1883-99, Standard Test Method for CBR (California Bearing Ratio) of Laboratory-Compacted Soils, ASTM International, West Conshohocken, PA, 1999.

ASTM D2166 / D2166M-16, Standard Test Method for Unconfined Compressive Strength of Cohesive Soil, ASTM International, West Conshohocken, PA, 2016.

ASTM D2487-98, Standard practice for classification of soils for engineering purposes (Unified Soil Classification System). In Annual Book of ASTM Standards. ASTM, International West Conshohocken, PA.

ASTM D422-63(2007) e2, Standard Test Method for Particle-Size Analysis of Soils (Withdrawn 2016), ASTM International, West Conshohocken, PA, 2007.

ASTM D4318-10e1, Standard Test Methods for Liquid Limit, Plastic Limit, and Plasticity Index of Soils, ASTM International, West Conshohocken, PA, 2010.

ASTM D4546-14, Standard Test Methods for One-Dimensional Swell or Collapse of Soils, ASTM International, West Conshohocken, PA, 2014.

ASTM D698-12e2, Standard Test Methods for Laboratory Compaction Characteristics of Soil Using Standard Effort (12 400 ft-lbf/ft3 (600 KN-m/m3)), ASTM International, West Conshohocken, PA, 2012.

ASTM D7928-16, Standard Test Method for Particle-Size Distribution (Gradation) of Fine-Grained Soils Using the Sedimentation (Hydrometer) Analysis, ASTM International, West Conshohocken, PA, 2016.


Full Text: PDF

DOI: 10.28991/cej-030988

Refbacks

  • There are currently no refbacks.




Copyright (c) 2017 Sadam Hussain

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.
x
Message